Owner manual

ManualsBrandsRockwell Automation ManualsEquipment1414-CCZxxxxxxx Current Sensor

Installation Instructions

Current Sensor

Catalog Numbers

1414-CCZ10FZWZDC, 1414-CCZ10FZWZDD,

1414-CCZ10FZWZDE, 1414-CCZ10FZWZDA

About the Current Sensor

These AC current sensors can be used to monitor fans, pumps, motor operation and failure,

conveyor belt, bearing loss, and other electrical loads. The current sensor requires no external

power supply since internal electronics are powered by the AC line induction being monitored

with an output-limited voltage clamp <12V DC.

Topic Page

About the Current Sensor 1

Important User Information 2

Install the Current Sensor 3

Specifications 4

ATTENTION: Never open a current-transformer secondary circuit with primary

current applied. Wiring between the CTs and the power monitor should include a

shorting terminal block in the CT secondary circuit. Shorting the secondary with

primary current present allows other connections to be removed if needed. An open

CT secondary with primary current applied produces a hazardous voltage, which

can lead to personal injury, death, property damage, or economic loss.

Summary of content (4 pages)

PAGE 1
Installation Instructions Current Sensor Catalog Numbers 1414-CCZ10FZWZDC, 1414-CCZ10FZWZDD, 1414-CCZ10FZWZDE, 1414-CCZ10FZWZDA Topic Page About the Current Sensor 1 Important User Information 2 Install the Current Sensor 3 Specifications 4 About the Current Sensor These AC current sensors can be used to monitor fans, pumps, motor operation and failure, conveyor belt, bearing loss, and other electrical loads.
PAGE 2
Current Sensor Important User Information Solid-state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (Publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://www.rockwellautomation.com/literature/) describes some important differences between solid-state equipment and hard-wired electromechanical devices.
PAGE 3
Current Sensor 3 Install the Current Sensor 1. Disconnect and lock-out all power sources during installation as severe injury or death can result from electrical shock due to contact with high voltage conductors. Ensure all installations are in compliance with applicable electrical codes and that the installation is completed by qualified installers familiar with the standards and proper safety procedures for high-voltage installation.
PAGE 4
5. Jumper the amperage range selected from sensor label chart. Remove the jumper for the None position. This example illustrates a 20 A mode. Amperes 0…50 0…20 0…10 Jumper HIGH MID NONE HIGH Input Range MID Specifications Technical Specifications - Current Sensor Attribute 1414-CCZ10FZWZDC, 1414-CCZ10FZWZDD, 1414-CCZ10FZWZDE, 1414-CCZ10FZWZDA Power supply Self-powered Response time 100 ms (0…90%) AC conductor hole Split core - 24 mm x 19 mm (0.95 in. x 0.75 in.) Solid core - Ø20 mm (0.8 in.