Owner's manual

Rockwell Automation Publication 1413-UM001D-EN-P - November 2010 25

Installation Chapter 2

4. Apply 24V DC power to the terminal.

Mount the PowerMonitor

1000 Unit

The PowerMonitor 1000 unit can be mounted on a panel or a DIN rail.

Panel Mount

Follow these steps to mount the unit on a panel or any flat surface.

1. Extend the top and bottom DIN-rail clips to the panel mount position.

2. Insert a small screwdriver under the spring pin to move the clip, lift it, and

pull the clip forward until it extends approximately 6 mm (0.25 in.) from

the enclosure.

3. Release the pin and lock the clip in the panel mount position.

4. Mount the unit by using three #8 machine screws.

DIN-rail Mount

You can mount the unit on standard 35 x 7.5 mm (EN 50 022 – 35 x 7.7) DIN-

rail. To mount on a DIN-rail, leave the mounting clips retracted so the mounting

holes are hidden behind the unit.

Install on a DIN-rail

Follow these steps to mount the unit on a DIN-rail.

1. Tilt the bottom of the unit slightly away from the rail until the notches

grab onto the top flange of the DIN-rail.

2. Push the bottom of the enclosure forward towards the DIN-rail.

The spring-loaded clip snaps onto the bottom of the rail and holds the unit

firmly in place.

Functional

Earth Ground

to Ground Bus