User Manual

12 Publication 1408-UM001B-EN-P - May 2008
Chapter 1 Powermonitor 1000 Overview
EtherNet/IP Protocol
The power monitor supports the EtherNet/IP protocol for
communicating via Ethernet or EtherNet/IP drivers in RSLinx Classic
software, or when using explicit messages from Rockwell Automation
controllers communicating via Ethernet or EtherNet/IP network.
Modbus TCP Protocol
Modbus TCP protocol is also supported for communicating via
Modbus TCP for communication.
TIP
When configuring Ethernet communication, you should verify
that IP addresses do not conflict with the existing
infrastructure, and that subnet masks and gateways are
properly set.