User Manual, PRIOR to Firmware rev. 3.0 Owner manual

Publication 1404-UM001D-EN-E - October 2004
Powermonitor 3000 EtherNet/IP Device Profile F-17
to the utility meter and propagated to other PM 3000s on the same
network.
Configuration Parameters
Before the DC can either produce or consume EOIP signals, it
requires the following configuration parameter:
Port
The UDP port number on which the EOIP signal packet will be
transmitted or received.
Dynamic Web Server
Functionality
The DC implements a dynamic web server so that run time data from
the PM 3000, as well as other web content desired, can be viewed by
any standard web browser on the network.
Configuring the Web Server
The DC's dynamic web server does not require any specific
configuration parameters from the PM 3000 during initialization.
Table F.32 End of Interval Pulse Task Configuration Parameters
Name Data Type
Port UINT
TIP
A port value of 0 disables both the EOIP producer
and consumer functionality.