User Manual, PRIOR to Firmware rev. 3.0 Owner manual

Publication 1404-UM001D-EN-E - October 2004
Powermonitor 3000 Data Tables A-29
Table A.20 Setpoint Output Actions
Applies to: Refer to Setpoint Setup/Read-Back Select and Status on page A-26
PM3000 Type See table
Param.
#
Parameter name M4
M5
M
6
M
8
Comment
0 None •••No output action, but recorded in the event log and Setpoint status
recorded.
1 Energize relay and set alarm flag 1 •••Refer to Table A.3 Discrete Data .
2 Energize KYZ and set alarm flag 2 •••
3 Set alarm flag 3 •••
4 Set alarm flag 4 •••
5 Set alarm flag 5 •••
6 Set alarm flag 6 •••
7 Set alarm flag 7 •••
8 Set alarm flag 8 •••
9 Set alarm flag 9 •••
10 Set alarm flag 10 •••
11 Set alarm flag 11 •••
12 Set alarm flag 12 •••
13 Set alarm flag 13 •••
14 Set alarm flag 14 •••
15 Set alarm flag 15 •••
16 Set alarm flag 16 •••
17 Save a trend log record •••Saves record even if periodic trending is disabled
18 Clear kWh result •••
19 Clear kVARh result •••
20 Clear kVAh result •••
21 Clear Ah result •••
22 Clear all energy results •••