User Manual, Firmware rev. 3.0 or LATER Owner's manual

3Publication XXXX-X.X.X - Month Year 3
Summary of Changes
Introduction
This release of this document contains new and updated information.
To find new and updated information, look for change bars, as shown
next to this paragraph.
Updated Information
The document contains these changes
Topic Page
Added information about single-instance
parameters
19
Single instance parameter for DeviceNet 77
Added Single Element Writes to the primary
methods to communicate with a power
monitor
80
Added information for writing single
element data to a data table
86
Added information about floating-point
word order
100
Added information for configuring protocol
selections
103
Changed the placeholder from instance 99
to instance 255
110
Added information about changing the
configuration of Instance 1 in the user
configured table
122
Added information about setpoint output
action logic
128
Added an example of sag alarm for setpoint
operation
133
Changed element 3 range in the Discrete
Data table to 0…7
193
Updated the Native Communication
Configuration table, it has nine elements
and the range for element 3 is 0…6
198
Updated the optional communication
configuration table for Ethernet, adding
protocol selection as element 13
199
Updated the optional communication
configuration table for DeviceNet, adding
floating point data format as element 4
202
Changed the element 4 range in the RS-232
table to 0…6
203