Installation Instructions Owner's manual

Publication 1403-IN005A-EN-P
2 Product Description
Features
The Ethernet Communication Card features include:
• Connect to Allen-Bradley PLC-5
®
Ethernet processors
• Connect to Allen-Bradley SLC 5/05™ Ethernet processor
• Built-in internet web page support
• Compatible with RSEnergy™, RSView32™ and RSPower32™
software
• Ethernet communication rate: 10Mbps
• Compatible with commercially available network bridges and routers
• Fully software configurable
• Supports RSLinx™ and WINtelligent Linx™ (emulates SLC 500™)
Figure 1 Catalog Number 1403-NENET Communications Module
Installation
1. Remove Master Module control power.
2. Remove the blank plate by unscrewing the two corner retaining screws
as shown i nFigure 2. Save these two screws for assembly.
Captive Fastening Screw
Finger Hold
Internal RS-232 Connector
10BT Connector
Internal 10B5 Connector
Receive (RX) LED
Transmit (TX) LED
Ready (RDY) LED
Link (LK) LED
ATTENTION
!
Please follow appropriate ESD procedures before removal
and/or installation of the Ethernet Communications Card.
Failure to follow these procedures can result in physical
damage to both the Ethernet Communications Card and
the Master Module.