Instruction Manual

362 Application Examples • SmartBelt Application
Publication 1398-PM601A-EN-P — October 2000
APPENDIXES
Flow Chart
ULTRA Plus
or IQ Parameter Settings
• CONFIGSet ULTRA Plus or IQ configuration to accept encoder 2 input for electronic gearing
• SCALEnumber of encoder counts per unit distance on driven belt
• SCALE2number of encoder counts per unit distance of belt
• ACCELallowable acceleration rate without slippage of product
• VELmotor top speed during correction at machine top speed
TITLE "SBELT"
;Version 3.00 2/29/96
PGMTYPE = MAINPGM
;
ASSIGN OFFSET V1 ;OFFSET is desired distance: flight to product
ASSIGN OFFSET2 V2
;
OFFSET = 1.2345 ;Set OFFSET in user units (inches, cm, etc.)
OFFSET2 = UTOC1 OFFSET ;Convert OFFSET to encoder counts
; based on SCALE parameter setting
INT1 CONT ;Enable interrupts to capture positions
INT2 CONT ;Input 11 is INT1, Input 12 is INT2
GEAR = 1.00 ;Initialize gear ratio
GEAREN ON ;Start tracking the master encoder
WAIT I11 ON ;Wait for first flight
;
MAIN: ;Main loop of program
CALCULATE CORRECTION DISTANCE
START
INITIALIZE VARIABLES
ACTIVATE INTERRUPTS
ACTIVATE ELECTRONIC GEARING
WAIT FOR A FLIGHT
PRODUCT?
PERFORM CORRECTION MOVE
MAKE SURE PRODUCT IS OFF SENSOR
NO
YES