Instruction Manual

Language Reference • Reference 265

Publication 1398-PM601A-EN-P — October 2000

WORDS

SCALE2

Distance Scale Axis 2 System

Purpose Set the scale used for encoder 2.

Syntax SCALE2 = value

variable = SCALE2

value The number of encoder counts per user unit of measure. Value

can be a constant, a nonvolatile variable Gn, a volatile variable

Vn, or a system variable. Va lu e must be a whole number. Frac-

tional scales are not permitted

variable The variable may be a nonvolatile variable Gn, a volatile vari-

able Vn, or a system variable.

Remarks See discussion for SCALE.

The SCALE2 statement should NOT be used while encoder 2 is in motion.

Changes made to this variable by a program are only in effect while the program is

running. When the program ends it will return to the value stored in the Personality

Module. If no change is made to this variable by the program, the value in the Person-

ality Module is used. The value in the Personality Module is set in the Parameter

menu, System dialog box.

See Also SCALE, CF, “Conversions” on page 131

Example

SCALE2 = 16000

SEN

Soft Enable Flag System

Purpose Soft enable Flag.

Syntax SEN= value

variable = SEN

value Value can be ON, OFF, a nonvolatile flag Bn, a volatile flag Fn,

or another system flag.

variable Variable can be a nonvolatile flag Bn, a volatile flag Fn, or

another system flag.

Remarks If SEN is ON, the controller is ENABLED. If SEN is OFF, the controller is DIS-

ABLED.