Owner manual

Options: Connectors and Shaft Seals

An environmentally sealed package may be formed when an N-Series motor is coupled with sealed

cable assemblies and shaft seals.

Factory manufactured power cables and encoder cables are available in standard cable lengths of 10,

25, 50, 75 and 100 feet (3, 7.6, 15, 23 and 30 meters). Factory cables provide environmental sealing

and shield termination.

Shaft Seal Kits

Connectors and Connector Kits

MOTOR SEAL KITS

MOTOR

SERIES

PART NUMBER

SIZE

(Outside Dia x Inside Dia x Width) mm/in

N-2300 0041-5068 0.035 x 0.001 x 0.005 / 0.875 x 0.250 x 0.125

N-3400 0041-5069 0.044 x 0.019 x 0.010 / 1.125 x 0.500 x 0.250

N-4200 0041-5070 0.044 x 0.025 x 0.010 / 1.125 x 0.625 x 0.250

N-5600 0041-5071 0.054 x 0.030 x 0.010 / 1.375 x 0.750 x 0.250

NOTE: Shaft seals are manufactured to inch dimensions. Millimeter dimensions are conversions from inches.

Shaft seals require a lubricant to reduce wear. Lubricant is provided with kit.

MOTOR POWER CONNECTORS

PART

NUMBER

CONNECTOR

TYPE

9101-1557 POWER - SOLDER

9101-1558 ENCODER - SOLDER

9101-1698 BRAKE - SOLDER

These connectors provide environmental sealing and shield termination.

OTHER MATING CONNECTORS

STRAIGHT CONNECTOR TYPE RIGHT ANGLE

MS3126F14-19S ENCODER - CRIMP KPSE08F14-19S PT08SE14-19S

MS3116F14-19S ENCODER - SOLDER KPT08F14-19S PT08E14-19S

MS3126F14-5S POWER - CRIMP KPSE08F14-5S PT08SE14-5S

MS3116F14-5S POWER - SOLDER KPT08F14-5S PT08E14-5S

MS3126F12-3S BRAKE - CRIMP KPSE08F12-3S PT08SE12-3S

MS3116F12-3S BRAKE - SOLDER KPTO8F12-3S PT08E12-3S

NOTES:

· These connectors provide environmental sealing, but do not provide cable shield termination.

· Angle Connectors are ITT Cannon (KP) and Amphenol (PT).

· Power contacts are size 16 AWG. Crimp type connectors accept wire sizes 20 AWG to 16 AWG.

· Brake and Encoder contacts are size 20 AWG. Crimp type connectors accept wire sizes 24 AWG to 20 AWG.