User Manual

Publication 1398-5.0 – October 1998

6-26 Interfaces

J1 Terminal Strip/Breakout Board

A 50-pin terminal strip kit is available for extending the signals from

the J1 connector. The kit includes a 1 meter (3-foot) interface cable, a

50-pin terminal strip and mounting hardware. Refer to “Options and

Accessories” on page A-1.

“Cabling Examples” on page B-26 depicts the use of this kit to pass a

cable through a bulkhead.

Figure 6.33 External CW/CCW (Step Up/Step Down) Interface via

Single-Ended Line Drivers (not recommended)

twisted pair

USER

CCW+

CCW-

J1 Drive

CW+

CW-

Drive Chassis

+5V

Supply

Return

+5 Volts

+5V

Supply

+5VDC

Connect only if J1 sources +5VDC power to user electronics.

5V @ 250 mA

ECOM

ELECTRONICS

CCW