User Manual

Publication 1398-5.0 – October 1998
TouchPad Instructions C-7
For example: If the SpeedWin setting is 5000 rpm and the
Maximum Speed in the motor table is
5200, pressing the key
increases the parameter to
5200 (the upper limit), but pressing the
key decrements the parameter to
4000.
The most significant digit is reserved when a parameter allows a
negative (-) setting or the parameter provides a list of possible
selections. The or key toggles the minus sign.
List
The most significant digit is reserved for an active/inactive selection
marker when a parameter provides a list of possible selections.
● A filled arrow, , in the most significant digit indicates the active
setting from a list of possible settings. Inactive settings are
indicated by a unfilled arrow, .
For example: If the drive is functioning as Preset Controller in the
Velocity mode, pressing the key from DRVPARAM scrolls
through the
CmdSrc list which includes Presets, AuxEnc,
StepDir, StepU/D, and Analog.
● The Mode/Enter, , key selects a parameter from the list.
● List selections that are undefined are indicated by Unknown.
This display indicates the TouchPad data table is incompatible
with the drive.
Lists are associated with all parameters, except
DISPLAY and
DRVINFO. Refer to page C-13 for items in each list. Table C.17,
“Drive Status List for TouchPad” on page C-16 is read-only; all other
lists contain possible parameter selections. After an option is selected,
the display reverts to the parameter from which the option was
selected.
For example: Selection of the EncAlign parameter under STATUS
provides the options Normal and Align. Selection of either
option returns you to the EncAlign display.