Installation Manual User guide

Publication 1398-5.2 – PDF 1997
Chapter 2
Unpacking, Inspecting and StoringChapter 2
This chapter describes the steps which ensure that the drive will
function as specified. The steps include:
● Unpacking the ULTRA 100 Series drive
● Inspecting the drive for shipping damage
● Testing the basic functionality of the drive
● Guidelines for storing the drive.
Unpacking the Drive 1. Remove the ULTRA 100 Series drive from the shipping carton
and remove all packing materials from the unit. The materials and
carton may be retained for storage or shipment of the drive.
2. Check all items against the packing list. A label located on the
side of the unit identifies:
• model number
• serial number
• manufacturing date code.
Inspection Procedure To protect your investment and ensure your rights under warranty, we
recommend the following steps be performed upon receipt of the unit:
● Inspect the unit for any physical damage that may have been
sustained during shipment.
● Perform the Inspections Test to verify the functionality of the unit.
If you find damage, either concealed or obvious, contact your buyer to
make a claim with the shipper. If degraded performance is detected
when testing the unit, contact your distributor or Rockwell
Automation to obtain a Return Material Authorization (RMA). Do
this as soon as possible after receipt of the unit.
“Our Warranty” on page Help-7 summarizes the period and conditions
under which ULTRA 100 Series drives are warranted against defects.