Installation Manual User guide

Publication 1398-5.2 – PDF 1997
TouchPad Instructions C-7
Displays
Text
A drive name longer than eight characters may require scrolling with
the Left, , and Right, , arrow keys. Drive names may be up to 32
characters in length.
Flashing characters in the Modify mode display are the characters that
are active.
● Change the cursor position and resolution using the and
keys. For example: If the Drv Name in the Modify mode displays
InFeed with the F flashing, pressing the key causes the first e
to flash.
● Press the or keys to increment or decrement a character by
scrolling through the list of valid ASCII characters. For example,
If the Drv Name in the Modify mode displays
InFfed with the
lowercase
f is flashing, pressing the key causes the flashing
character to decrement to
e.
Numeric
Flashing characters in the Modify mode display are the numbers that
are active.
● Change the cursor position and resolution using the or key.
For example: If the Over Spd in the Modify mode displays
5200
and
52 is flashing, pressing the key causes 520 to flash.
● Press the or key to increment or decrement these numbers.
For example: If the Over Spd value is
5200 and 52 is flashing,
pressing the key causes the setting to increment by 100 rpm
each time the key is pressed.
● Parameter values may not exceed the maximum or minimum
limits, regardless of the cursor position.
For example: If the SpeedWin setting is
5000 rpm and the
Maximum Speed in the motor table is
5200, pressing the key
increases the parameter to
5200 (the upper limit), but pressing the
key decrements the parameter to
4000.
The most significant digit is reserved when a parameter allows a
negative (-) setting or the parameter provides a list of possible
selections. The or key toggles the minus sign.
List
The most significant digit is reserved for an active/inactive selection
marker when a parameter provides a list of possible selections.