Installation Manual User guide

Publication 1398-5.2 – PDF 1997
8-46 Application and Configuration Examples
– Baud Rate: 9600
– Data Bits: 8
– Parity: None
– Stop Bits: 1
– Serial Port: COM1
Refer to “RS-232 Communication Test” on page 11-8 for
troubleshooting instructions.
6. Select
Read Drive Parameters from the Communications menu.
7. Verify the Drive Name and Address are correct for the drive that is
being addressed.
8. Choose
OK to load the drive parameters.
9. If the message box appears that a motor must be selected, select
OK. The Drive Setup window is displayed with Motor Model
selection parameter active. The motor may be selected from the
drop down box. If this message box does not appear, the motor
displayed in the Motor Model box was previously selected.
10. Select or verify the correct motor model number from the drop
down Motor Model list.
11. If a message advises that the drive must be reset, choose
Yes.
12. Select
Indexing as the Operation Mode for the drive.
13. Choose
Close to exit the Drive Set Up window.
14. Choose the
Drive Parameters command icon from the Drive
window and then select the
Indexing tab.
15. Select the following values for Index 0
:
16. Choose
Close to exit the Drive Parameters window.
17. Verify the Status indicator is green.
18. Select the
I/O Configuration command icon from the Drive Win-
dow.
Note: A motor must be selected for the parameters to load.
Absolute as Mode
8000 as Position
1 as Batch Count
0 as Dwell
Appropriate values for
Velocity, Acceleration and
Deceleration