Installation Manual User guide

Publication 1398-5.2 – PDF 1997
Application and Configuration Examples 8-3
• If the settings are correct, select OK in the Port - Settings dia-
log box.
• If the settings are different, correct the Port - Settings to allow
communications with the drive.
Factory default communications Port - Settings for the drive
are:
– Baud Rate:
9600
– Data Bits: 8
– Parity: None
– Stop Bits: 1
– Serial Port: COM1
Refer to “RS-232 Communication Test” on page 11-8 for
troubleshooting instructions.
6. Select
R
ead Drive Parameters from the Communications menu.
7. Verify the Drive Name and Address are correct for the drive that is
being addressed.
8. Choose
OK to load the drive parameters.
9. If the message box appears that a motor must be selected, select
OK. The Drive Set Up window is displayed with Motor Model
selection parameter active. The motor may be selected from the
drop down box. If this message box does not appear, the motor
displayed in the Motor Model box was previously selected.
10. Select or verify the correct motor model number from the drop
down Motor Model list.
11. If a message advises that the drive must be reset, choose
Yes.
12. Select the Operation Mode parameters for the drive:
13. Choose
Close to exit the Drive Set Up window.
14. Choose the
Drive Parameters icon from the Drive window and
then select the
Analog tab.
15. Enter appropriate S
cale and Offset values for the input.
16. Verify the Status indicator is green.
Note: A motor must be selected for the parameters to load.
Velocity Mode Settings Torque Mode Settings
Analog Velocity Input
as the Operation Mode
Analog Torque Input as
the Operation Mode