Instruction Manual

Index
I–2
Publication 1397–5.0 – June, 2001
G
Ground System and Conduit Screen
Termination, BĆ10
Grounding Procedures, 2Ć8
Grounding Requirements, BĆ8
H
Hidden Parameters, 5Ć100
HIM Description, 3Ć1
HIM Fault Display, 6Ć2
HIM Operation, 3Ć5
HIM Programming Steps, 3Ć6
I
Installation, 2Ć1
Internal Wiring Guidelines, BĆ11
I/O Inputs 24V, 4Ć26
J
Jumper and Adjustment Settings,
4Ć21
Jumper Settings, 4Ć20
L
Lifting Angle Arrangement, EĆ4
Lifting Component Ratings, EĆ1
Logic Command Format, DĆ12
Logic Inputs, 1Ć7
Logic Outputs, 1Ć7
Logic Status Format, DĆ12
Logic Status Parameter, DĆ1
Loss of Communications Fault, DĆ5
M
Motor and Feedback Polarity
Checks, 4Ć29
Motor Ground Check, 4Ć6
Mounting, 2Ć1
Mounting Environment, 2Ć1
Mounting Hole Pattern, EĆ2
Mounting the AC Line Filter, BĆ4
Mounting the Drive, BĆ4
N
Numeric Parameter Table, 5-6
O
Options, 1Ć10
P
Parameter (Alphabetical), 5Ć97
Parameter Descriptions, 5Ć14
Parameter Groups, 5Ć2
Parameter SetĆUp, 4Ć15
PreĆPower Checks, 4Ć6
Power Ć On Checks, 4Ć14
Power Ratings and Supply Capacity,
1Ć6
Power Wiring Procedure, 2Ć17
PreĆPower Checks, 4Ć6
Programming HIM, 3Ć6
Programming Parameters, 5Ć1
Pulse Encoder Polarity Checks, 4Ć34
R
Regulator Board Hardware Jumper
Settings, 4Ć20
Regulator Board Input Signals, 2Ć31
Regulator Board Jumpers, 4Ć25
Remote I/O Communications
Module, DĆ10
S
Safety Ground, 2Ć8
SCANport Configuration, DĆ3
SCANport I/O Image, DĆ5