Instruction Manual

Chapter 5
Publication 1397-5.0 — June, 2001
Programming Parameters
This chapter contains the information required to assist the user in
programming the Drive for a specific application after initial
start-up. Drives are shipped programmed with default values and are
preconfigured for the factory installed options.
The Drive parameters are divided into the following categories:
Diagnostics – These parameters provide information on various test,
status and alarm inputs.
Masks – These parameters contain binary masks for all control
functions. The masks control which adapters can issue control
commands.
Owners – These parameters contain binary information to display
which group of adapters is issuing control command.
Adapter I/O – Input and Output parameters for the optional
communication adapter board used with the 1397.
Process Display – These parameters provide input to the Human
Interface Module programming device.
Field – These parameters allow you to alter Field Supply levels,
delays, current references, gain, etc.
Process PI – Status & Reference parameters for the Outer Control
Loop.
Metering – These parameters allow you to monitor various
reference sources such as Analog Inputs, Speed Loops, Current
Loops, Ramp Input and Outputs etc.
Setup – These parameters define basic operation and require
configuration during the Start-Up procedure.
Advanced Setup – These parameters require configuration during
Start-Up when selected options are used, or with advanced and
complex applications.
Reference Set – These parameters allow you to select options such
as Accel/Decel times, Preset speeds, Jog times etc.
Feature Select – This parameter group contains the necessary
parameters to activate and program advanced features of the Drive.
Input Configuration – These parameters accept analog information
from sources outside the Drive.
Output Configuration – These parameters provide analog & digital
output information.
Record any changes made to the parameters for future reference
during troubleshooting or tuning. A User Parameter value chart is
supplied in Appendix D.
Introduction
Record Keeping