User Manual

1397 115VAC Control Interface Card 2
1397-5.18 March, 1997
115V AC
COM
8.2kΩ, 2W
3.4kΩ, .5W
.01µF
1µF
COM
DC OUT
COM
Typical 115V AC Control Interface Card I/O Circuit
SOURCE DRIVER
Card Height: 224.8mm (8.85 in.)
Dimensions Width: 88.9mm (3.50 in.)
Depth: 38.1mm (1.5 in.) Including Mounting
Standoff
Input Circuit Number of Command Inputs: 10
Operating Voltage: 140VAC Max./120VAC Nominal
Turn-On Voltage: 65VAC Min.
Turn-Off Voltage: 50VAC Max.
Input Current: 12mA per Input at 120VAC
Total Input Current: 120mA Max. at 120VAC
Turn-On Delay: 8.0mS Max.
Turn-Off Delay: 2.0mS Max.
Ground: Inputs Have Common Ground
Output Circuit Number of Command Outputs: 10
Operating Voltage: 35VDC Max./24VDC Nominal
Max. Current: 500mA Single Channel
3A All Channels
Max. Leakage Current: 0.1mA
Max. ON State Voltage Drop: 2V
Ground: Outputs Have Common Ground
Specifications
Circuits used with the 115VAC Interface Card must be cable of
operating with high = true logic. In the low state, circuits must generate
a voltage of no more than 50VAC. Leakage current must be 2.5-5mA
into a 10k
Ω /3Wload. In the high state, circuits must generate a voltage
of 65-140VAC and source a current of approximately 12mA for each
input.