User guide

Publication 1395-RTP-5.1 - September 1997
Start-Up Instructions 3-9
Cross Reference The printing diameter Tables 3 through 6 provide the proper tracking
information such as the number of gear teeth for the magnetic pickup
gear, the maximum belt motor speed and the press shaft speed at
maximum press impressions per hour. The main tracking Parameter
(Parameter 562) should be set at the maximum press shaft speed that
corresponds to the maximum press impressions per hour. The value
used for default is 2566.
Table 3: Cross Reference
(Printing Diameter = 14-1/32; Gear Teeth = 131)
IMP/
HOUR
RTP PRESS
SPD. SENSOR
FREQ (HZ)
WEB
VELOCITY
(FT/MIN)
BELT
MOTOR
RPM
PRESS
DRIVE
SHAFT RPM
100 7.28 3.06 2.08 3.33
400 29.11 12.24 8.32 13.33
600 43.67 18.37 12.48 20.00
800 58.22 24.49 16.64 26.67
1000 72.78 30.61 20.80 33.33
1200 87.33 36.73 24.96 40.00
2000 145.56 61.22 41.60 66.67
4000 291.11 122.45 83.20 133.33
6000 436.67 183.67 124.80 200.00
8000 582.22 244.89 166.40 266.67
10000 727.78 306.11 208.00 333.33
12000 873.33 367.34 249.60 400.00
14000 1018.89 428.56 291.20 466.67
16000 1164.44 489.78 322.80 533.33
18000 1310.00 551.00 374.40 600.00
20000 1455.55 612.23 416.00 666.67
22000 1601.11 673.45 457.60 733.33
24000 1746.66 734.67 499.20 800.00
26000 1892.22 795.89 540.80 866.67
28000 2037.78 857.12 582.40 933.33
30000 2183.33 918.34 624.00 1000.00
32000 2328.89 979.56 665.60 1066.67
34000 2474.44 1040.78 707.20 1133.33
36000 2620.00 1102.01 748.80 1200.00
38000 2765.55 1163.23 790.39 1266.67