Reference Adapter for RTP Applications User Manual
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- Who Should Use This Manual
- Purpose of This Manual
- Safety Precautions
- Contents of This Manual
- Related Documentation
- Information on the Intelligent Terminal System (ITS)
- Bulletin 1300 Intelligent Terminal System Documentation Set
- Allen-Bradley offers support services worldwide, with Sales/Support Offices, authorized distribut...
- Contact your local Allen-Bradley representative for:
- If you need to contact Allen-Bradley for technical assistance, please review the product and trou...
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter Content
- 1. These steps should already have been performed on a custom Drive manufactured and shipped as a...
- 2. If a Drive that has already been installed is receiving a Digital Reference Adapter Board as a...
- 3. If for any reason a given Drive loses the EE memory information, it will also be necessary to ...
- 4. Should there be a need to check or download parameters to the Drive, use of the ITS device wil...
- 1. Establish Configuration Links between Drive and the Digital Reference Adapter Board.
- 2. Program Digital Reference Adapter Set-Up Parameters.
- Terminology
- Parameter Set-Up Description
- Example Start-Up Configuration (Linking)
- Digital Input/Output Set-up
- Analog Input/Output Set-up
- Configuration Links Set-up
- Chapter Content
- Chapter 6
- Introduction
- 1. Hard Faults Hard Faults are nonrecoverable. That is, the 1395 Drive must either be RESET or PO...
- 2. Soft Faults Soft Faults occur when an Adapter Board detects a condition which may result in un...
- 3. Warning Faults Conditions detected within the system that may produce Soft Faults if the condi...
- Digital Reference Fault Messages
- Adapter Troubleshooting
- Introduction
- Chapter 7
- Chapter 8
- Index
- Back Cover
Index
Publication 1395-RTP-5.2 - September 1997
A
Adapter Troubleshooting, 6-3
Analog Input/Output Set-up, 5-4
AnalogInputs,1-2,1-3,2-5
Analog Outputs, 1-2, 1-3, 2-5
B
Board Features, 1-1
Board Function, 2-1
C
Configuration Links Set-up, 5-4
Configuration Parameters, 8-6
Connections to Drive, 4-3
Connections to Terminal Block 3 (TB-3) on Drive,
4-4, 4-5
Contamination, 7-1
Control Description, 3-1
D
Description of Equipment, 1-1
Digital Input/Output Set-up, 5-4
Digital Inputs, 1-3, 2-3
Digital Outputs, 2-4
Digital Reference Adapter Board Location –
Port A, 4-3
Digital Reference Fault Messages, 6-1
Digital Reference Input, 1-1, 1-3, 2-2
Discrete Inputs, 1-1
Discrete Outputs, 1-2, 1-3
Drive Logic States, 3-3
Drive Reference Control States, 3-3
E
ESD Precautions, 4-2
Example Start-Up Configuration (Linking), 5-2
F
Final Check Out, 7-2
Firmware Location, 2-6
H
Hard Faults, 6-1
Hardware Description, 2-1
I
Installation, 4-1
Introduction, 1-1
K
“Keep Good Maintenance Records”, 7-2
L
LED Indicators, 1-2
M
Mounting, 4-2