Owner manual

Chapter 9
Reference Materials
9-12
Parameter Reference Listing (Alphabetical)
PARAMETER NAME PARAMETER NO. PAGE REFERENCE
Maintain Start 624 7-38
Minimum Tapered Current 667 7-49
MOP Accel 1 – 4 641 – 644 7-43 – 7-44
Mtr Overload Sel 629 7-40
MOP Decel 1 – 4 645 – 648 7-44 – 7-45
MOP Max Speed 649 7-45
MOP Min Speed 650 7-45
Motor Arm FLA 611 7-34
Motor Inertia 613 7-34
Overload Pending 720 7-62
Position Error 109 7-21
Position Feedback 107 7-21
Preramp 102 7-20
Preset Speed 1 – 5 633 – 637 7-41 – 7-42
Process Trim Feedback 162 7-31
Process Trim Filter 713 7-61
Process Trim Hi Sum 722 7-63
Process Trim Select 628 7-40
Process Trim Hi Lim 718 7-62
Process Trim KI Gain 715 7-61
Process Trim Lo Lim 717 7-62
Process Trim Lo Sum 721 7-63
Process Trim Output Gain 719 7-62
Process Trim Preload 714 7-61
Process Trim PT Input 125 7-24
Process Trim Ref 161 7-31
Process Trim Output 119 7-23
Rated AC Line 617 7-35
Rated Arm Brdg 1 615 7-35
Rated Field Brdg 1 616 7-35
Rate Fld Mtr Cur 612 7-34
Rated Motor Volt 610 7-34
Ramp Vel Ref 103 7-20
Rev Brdg Cur Lim 664 7-48
Rev Speed Lim 607 7-33
SCR Overtemp Dly 726 7-64
Slave Percent 2 670 7-49
Stall Delay 727 7-64
SP Indirect 1 – 5 840 – 844 7-70 – 7-72
SP Output 1 – 5 10 – 14 7-15