User guide

Chapter 2

Hardware Description

2-17

Options Programming Terminal Interface – The Handheld Programming

Terminal (HHT) is used to access information in the firmware of the 1395.

Keypads on both the handheld programming terminal and the

door-mounted terminal (shown in Figure 2.14) can be used to perform the

following functions:

• Monitor real time parameter values

• Change parameter values

• Start/Stop the drive (depending on Model of Programming Terminal)

• Set drive configuration

• Backup parameter values to EEPROM

• Monitor fault information

Interface between the 1395 Main Control Board and the handheld

Programming Terminal is accomplished using a 9 pin type connector

physically mounted on the end of TB3. The cable coming from the D-shell

connector is connected to J4 on the Main Control Board. For a detailed

description of the Programming Terminal, refer to the Programming

Terminal Installation and Operation Manual.

Figure 2.14

Programming Terminal

AB0446A

LOCAL

PROGRAMMING TERMINAL

START

JOG

STOP

ALT

LOCAL

DEC

REMOTE

INC

PRE 4

PRE 5

X REF

PRE 1

PRE 2

PRE 3

HOME

BASE

DEL

+/–

ENTER