User guide

Chapter 7
Reference Materials
7-12
PARAMETER NAME PARAMETER NO. PAGE REFERENCE
MOP Accel 1 – 4 641 – 644 5-43 – 5-44
MOP Decel 1 – 4 645 – 648 5-44 – 5-45
MOP Max Speed 649 5-45
MOP Min Speed 650 5-45
Motor Arm FLA 611 5-34
Motor Inertia 613 5-34
Mtr Overload Sel 629 5-40
Overload Pending 720 5-62
Position Error 109 5-21
Position Feedback 107 5-21
Preramp 103 5-20
Preset Speed 1 – 5 633 - 637 5-41 – 5-42
Process Trim Feedback 162 5-31
Process Trim Filter 713 5-61
Process Trim Hi Sum 722 5-63
Process Trim Select 628 5-40
Process Trim Hi Lim 718 5-62
Process Trim KI Gain 715 5-61
Process Trim Lo Lim 717 5-62
Process Trim Lo Sum 721 5-63
Process Trim Output Gain 719 5-62
Process Trim Preload 714 5-61
Process Trim PI Input 125 5-24
Process Trim Ref 161 5-31
Process Trim Output 119 5-23
Rated AC Line 617 5-35
Rated Arm Brdg 1 615 5-35
Rated Field Brdg 1 616 5-35
Rate Fld Mtr Cur 612 5-34
Rated Motor Volt 610 5-34
Ramp Vel Ref 103 5-20
Rev Brdg Cur Lim 664 5-48
Rev Speed Lim 607 5-33
SCR Overtemp Dly 726 5-64
Slave Percent 2 670 5-49
Stall Delay 727 5-64
SP Indirect 1 – 5 840 – 844 5-69 – 5-70
SP Output 1 – 5 10 – 14 5-15
Parameter Reference Listing (Alphabetical)