User guide

Chapter 6
Start–Up
6-3
Figure 6.1
Bulletin 1395 Start-Up Sequence
External
Connection Checks
PRE-POWER CHECKS
Internal
Connection Checks
Feedback Board
Jumper Check
LIVE-POWER CHECKS
Incoming
Voltage Checks
Logic
Level Checks
Polarity
Checks
Monitor
Armature Voltage
PARAMETER PROGRAMMING
START-UP
With
Node Adapter
With
Discrete Adapter
TUNING
Pre-Power Checks
1. Verify all procedures listed in Chapter 4 Installation, have been
properly completed.
2. If you have not already done so, record the following information on
the Pre-Power Checklist Table on page 6-4.
• Drive order number
• Drive nameplate data
• Motor nameplate data
• Tachometer/Encoder data (if applicable)
• Adapter boards used
• External devices interfaced with Drive such as PLC, discrete I/O etc.