Instruction Manual

Start-Up 6–9
Open Enable Signal
Restore Enable Signal
10. If a PLC control drive is being used, Stop the drive and go to step 11.
Thefollowingsteps willcheckforcorrect driveoperationwhen theEnableinput
is removed.
A. With the drive still running, open the Enable signal. The drive should stop
and indicate “Not Enabled” on the display. Restore the Enable signal.
B. Reset the drive by pressing the Stop key.
Not Enabled
–0.00 Hz
Press & Hold Jog Key
Release Jog Key
11. Jog Control & Stop Mode Check.
A. Withthedrivereset,butnotrunning,pressandholdtheJogkey.Themotor
should accelerate to the frequency programmed by the [Jog Frequency]
parameter andremain there until theJog keyis released. When released,
thedriveshouldexecuteastopfunction usingtheprogrammedstopmode.
Verify that the correct stop mode was initiated.
At Speed
–10.00 Hz
Stopped
–0.00 Hz
Set to Maximum
Frequency
12. Checking Accel and Decel Times.
A. Verify that the frequency command is at maximum frequency.
B. Startthedriveandobservetheamountoftimethedrivetakestoaccelerate
tomaximumfrequency.Thisshould equal10seconds,whichisthe factory
default value for the [Accel Time 1] parameter.
C. Press the Reverse key and observe the amount of time the drive takes to
decelerate from maximum frequency to zero. This time should equal the
time set in the [Decel Time 1] parameter (default is 10 seconds). If these
timesare notcorrectforyourapplication,referto Chapter7forinstructions
on programming changes.
Important: With [Direction Mask] set to the default value, the reverse
command must be issued from the HIM or other adapter. If the reverse
command is to be issued from TB5, [Direction Mask] must first be
programmed to allow direction control from TB5.
D. Stop the drive.
Stopped
+0.00 Hz
Remove ALL Power
Reconnect Motor
13. Reconnect the Motor.
A. Remove and lock-out the input and control power to the drive. When the
HIM Display is no longer illuminated, remove the drive cover.
B. Reconnect motor leads and replace cover.
Advanced Start-Up Procedure
Press these keys . . . while following these steps . . . The HIM Display will show . . .
ATTENTION: To avoid a hazard of electric shock, verify that the
voltageon the bus capacitorshasdischarged. Measurethe DC bus
voltage at terminals 47 (+) and 45 (–). The voltage must be zero.
!