Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipment1336Z SPIDER - FRN 2.xxx-5.xxx

Start-Up 6–3

Reset Factory Defaults

2. Important: Theremaining stepsin thisprocedure arebased onfactory default

parameter settings. If the drive has been previously operated, parameter

settings may havebeenchangedandmay notbe compatible withthis start-up

procedure or application. Drive status and fault conditions may be unpredict-

able when power is ﬁrst applied.

To obtain proper results, the parameters must be restored to factory default

settings.After restoringtofactorydefaults,severalparametersmustbe initially

set as explained below.

A. From the Status Display, press Enter (or any key). “Choose Mode” will be

displayed.

B. Press the Increment (or Decrement) key until “EEPROM” is displayed. If

EEProm is notin the menu, programming is password protected.Refer to

Chapter 5 for Password information.

C. Press Enter.

D. PresstheIncrement(orDecrement)keyuntil“ResetDefaults”isdisplayed.

E. Press Enter to restore all parameters to their original factory settings.

F. Press ESC. “Reprogram Fault” will display, indicating successful reset.

G. Press the Stop key to reset the fault. Refer to page A–12 and program

parameters 36, 242-244. Cycle power.

Choose Mode

Display

Choose Mode

EEProm

Reset Defaults

Choose Mode

EEProm

Reprogram Fault

F48

Stopped

+0.00 Hz

3. From the StatusDisplay, press the Enter key (or any key). “Choose Mode” will

be displayed.

A. Press the Increment (or Decrement) key until “Startup” is displayed.

B. Press Enter.

Important: All questions can be answered Yes or No. Pressing Enter will

select the default (“Y” or “N”). Pressing the Increment (or Decrement) key will

change the selection – press Enter to select. Choosing “Y” allows you to pro-

ceed through the step, “No” will advance you to the next step. In addition, the

following should be noted:

• The“Startup”modecanbeexitedatanytimebypressingESCapeuntilthe

StatusDisplayisshown. Ifyouwishto re-enterthe “Startup” mode,simply

select “ResetSequence” tostart fromthebeginning.Selecting “Continue”

allows you to resume from the point where you left off.

• Completingthelastactioninanystepwillautomaticallytakeyoutothenext

step.

• Pressing SELect will activate line 2 of the display – this must be done for

all values.

• Press the Increment (or Decrement) key to adjust a value (skip if value is

correct).PressEntertostorethevalueorretaintheexistingvalue.Pressing

Enter again will cause you to move to the next step (parameter).

Choose Mode

Display

Choose Mode

Startup

Assisted Start-Up

Keys Description The HIM Display will show . . .