Instruction Manual

Human Interface Module 5–13

Handheld HIM Operation If remote programming is desired, a handheld HIM can be connected

to the drive. Refer to Adapter Definitions in Chapter 2 for details.

Important: Disconnecting a HIM (or other SCANport device) from a

drive while power is applied will cause a “Serial Fault,”

unless the [Logic Mask] parameter has been set to disable

this fault or Control Logic (Control Status menu) has been

disabled(exceptSeriesAHIMsbelowversion3.0).Setting

Bit 1 of the [Logic Mask] parameter to “0” will disable

“Serial Fault” from a HIM on port 1. Note that this also

disables all HIM control functions except Stop.

Password Mode (continued)

Press these keys . . . while following these steps . . . The HIM Display will show . . .

menus are now password protected and will not appear in the menu.

To access these modes, perform the following steps.

A. Press the Increment (or Decrement) key until “Password” is

displayed.

B. Press Enter. “Login” will be displayed.

C. Press Enter, “Enter Password” will be displayed.

D. PresstheIncrement(orDecrement)keyuntilyourcorrectpassword

isdisplayed.The SELectkeywillmovethecursor (exceptSeriesA

HIMs below version 3.0).

E. Press Enter.

F. The Program and EEProm modes will now be accessible. To pre-

ventfutureaccesstoprogramchanges,logoutasdescribedbelow.

Choose Mode

Password

Enter Password

< 0>

Enter Password

< 123>

Choose Mode

Password

Logout from Drive 3. To prevent unauthorized changes to parameters, Logout must be per-

formed as described below.

A. Press the Increment (or Decrement) key until “Password” is

displayed.

B. Press Enter.

C. PresstheIncrement(orDecrement)keyuntil“Logout”isdisplayed.

D. Press Enter to log out of the Password mode.

Choose Mode

Password

Logout

Choose Mode

Password