Instruction Manual

5–12 Human Interface Module

Password Mode

Press these keys . . . while following these steps . . . The HIM Display will show . . .

Modify Password 1. The factory default password is 0 (which disables password protec-

tion). To change the password and enable password protection, per-

form the following steps.

A. Fromthe StatusDisplay, pressEnter (oranykey).“Choose Mode”

will be shown.

B. Press the Increment (or Decrement) key until “Password” is

displayed.

C. Press Enter.

D. PresstheIncrement(orDecrement)keyuntil“Modify”isdisplayed.

E. Press Enter. “Enter Password” will be displayed.

F. Press the Increment (or Decrement) key to scroll to your desired

newpassword.TheSELectkeywillmovethecursor(exceptSeries

A HIMs below version 3.0).

G. Press Enter to save your new password.

H. Press Enter again to return to the Password Mode.

I. PresstheIncrement(orDecrement)keyuntil“Logout”isdisplayed.

J. Press Enter to log out of the Password mode.

K. The Password mode can be programmed to appear when drive

poweris applied(except Series AHIMs below version3.0). Simul-

taneously press the Increment and Decrement keys while the

Password display is shown.

Choose Mode

Display

Choose Mode

Password

Modify

Enter Password

< 0>

Enter Password

< 123>

Choose Mode

Password

Logout

Choose Mode

Password

Sets Password Display

as Power-Up Display