Instruction Manual

Human Interface Module 5–11
Control Status Mode (continued)
Press these keys . . . while following these steps . . . The HIM Display will show . . .
Fault Queue/Clear Faults 2. This menuprovidesameans toview the fault queueand clearitwhen
desired.
A. FromtheControlStatusmenu,presstheIncrement(orDecrement)
key until “Fault Queue” is displayed.
B. Press Enter.
C. Press the Increment (or Decrement) key until “View Faults” is
displayed.
D. PressEnter.Thefaultqueuewillbedisplayed.“Trip”displayedwith
a fault will indicate the fault that tripped the drive.
E. Use the Increment (or Decrement) key to scroll through the list.
F. To clear the fault queue, press ESCape. Then use the Increment/
Decrementkeystoselect“ClearQueue.” PressEnter.Pleasenote
that “Clear Queue” will not clear active faults.
Control Status
Fault Queue
Fault Queue
View Faults
Serial Fault
F 10 Trip 1
Reprogram Fault
F 48 2
Fault Queue
Clear Queue
or
or
or
or&