Instruction Manual

5–10 Human Interface Module

Search Mode

Press these keys . . . while following these steps . . . The HIM Display will show . . .

1. The Search Mode is not available with a Series A HIM below version

3.0.

This modeallows youto search throughtheparameterlist and display

all parameters that are not at the factory default values.

A. Fromthe StatusDisplay, pressEnter (oranykey).“Choose Mode”

will be shown.

B. PresstheIncrement(orDecrement)keyuntil“Search”isdisplayed.

C. PressEnter.TheHIMwillsearchthroughallparametersanddisplay

any parameters that are not at their factory default values.

D. Press the Increment (or Decrement) key to scroll through the list.

Choose Mode

Display

Choose Mode

Control Status Mode

Press these keys . . . while following these steps . . . The HIM Display will show . . .

Control Logic 1. The Control Status mode is not available with a Series A HIM below

version 3.0.

This mode allows the drive logic mask to be disabled, thus preventing

a Serial Fault when the HIM is removed while drive power is applied.

The logic mask can be disabled with Series A HIMs (versions below

3.0) by using [Logic Mask] as explained on page 5–13.

A. Fromthe StatusDisplay, pressEnter (oranykey).“Choose Mode”

will be shown.

B. Press the Increment (or Decrement) key until “Control Status” is

displayed. Press Enter.

C. Select“ControlLogic”usingtheIncrement/Decrementkeys.Press

Enter.

D. Press theSELect key, thenusethe Increment (orDecrement) key

to select “Disabled” (or “Enable”).

E. Press Enter. The logic mask is now disabled (or enabled).

Choose Mode

Display

Choose Mode

Control Status

Control Logic

Disabled

or &

or&