Instruction Manual
Human Interface Module 5–7
Program and Display Modes
Press these keys . . . while following these steps . . . The HIM Display will show . . .
1. The DisplayandProgrammodesallowaccess to the parameters for viewingor
programming.
A. From the Status Display, press Enter (or any key). “Choose Mode” will be
shown.
B. Press the Increment (or Decrement) key to show “Program” (or “Display”).
C. Press Enter.
D. PresstheIncrement(orDecrement)keyuntilthedesiredgroupisdisplayed.
E. Press Enter.
F. Press the Increment (or Decrement) key to scroll to the desired parameter.
Choose Mode
Display
Choose Mode
Program
Choose Group
Metering
Output Current
0.00 Amps
Bit ENUMs (16 character text strings) will be displayed (except Series A HIMs
below software version 3.0) to aid interpretation of bit parameters.
G. Select a bit parameter with the Increment (or Decrement) keys.
H. Press the SELect key to view the ENUM of the first bit. Pressing this key
again will move the cursor to the left one bit.
A blinking underline cursorwill indicate thatyou areinthe Displaymodeor
that a Read Only parameter as been accessed. A flashing character will
indicate that the value can be changed.
Individualbits ofa Read/Writeparametercan bechanged inthesame man-
ner. Pressing the SELect key will move thecursor (flashing character)one
bit to the left. That bit can then be changed by pressing the Increment/
Decrement keys. When the cursor is in the far right position, pressing the
Increment/Decrement keys will increment or decrement the entire value.
Masks
Logic Mask
TB4-6
X111111
1
or
or
or
or
Process Mode
Press these keys . . . while following these steps . . . The HIM Display will show . . .
Process Mode 1. When selected, the Process mode will show a custom display consisting of
information programmed with the Process Display group of parameters.
A. Follow steps A-C on the preceding page to access the Program mode.
B. PresstheIncrement/Decrementkeyuntil“ProcessDisplay”isshown.Press
Enter.
C. Using theIncrement/Decrement keys,select [Process 1Par] andenter the
number of the parameter you wish to monitor. Press Enter.
Choose Mode
Program
Choose Group
Process Display
Process 1 Par
1
or &
or &