Instruction Manual

Installation/Wiring for Stand-Alone Drives 3–11
Optional Analog I/O
Configurations
Option Board Installation/Removal
The desired analog option boards can be user installed. Prior to
installation, the jumpers at Slot A and/or Slot B must be removed. If a
board is removed at a later time, the jumpers must be reinstalled.
Refer to the detailed instructions supplied with the option boards.
Option Board Setup
Before operation, each installed option board must configured. The
board will have one or two DIP switches depending on the option
selected. The first function (input or output) is configured with the S1
DIP switch – the second function (if present) is configured with S51.
Using the table below, set the switch(es) for correct operation.
Important: Due to different switch manufacturers, the individual
switches will be designated “A or 1” and “B or 2.” In
addition, switch positions will be indicated as “Off or 0”
and “On or 1.”
S1 and S51 Configuration Settings
!
ATTENTION: Drive power mustbe removedprior to
jumper installation/removal.
Option
DIP Switch S1 DIP Switch S51
Function Mode
Switch Setting
Function Mode
Switch Setting
A/1 B/2 A/1 B/2
LA1 Output 0 10V Off/“0” Off/“0”
Configure Standard Analog Input 2 with J11.
See page 3–10 for further information.
20mA On/“1” On/“1”
LA2 Input 0 10V Off/“0” On/“1” Input 1 10V Off/“0” On/“1”
20mA On/“1” Off/“0” 20mA On/“1” Off/“0”
LA3 Output 0 10V Off/“0” Off/“0” Output 1 10V Off/“0” Off/“0”
20mA On/“1” On/“1” 20mA On/“1” On/“1”
LA4 Input 2 10V Off/“0” On/“1” Output 1 10V Off/“0” Off/“0”
20mA On/“1” Off/“0” 20mA On/“1” On/“1”
LA5 Output 0 10V Off/“0” Off/“0”
20mA On/“1” On/“1”
LA6 Input 0 10V Off/“0” On/“1”
20mA On/“1” Off/“0”
LA7 Input 0 10V Off/“0” On/“1” Input 1 10V Off/“0” On/“1”
20mA On/“1” Off/“0” 20mA On/“1” Off/“0”
1
2
On / 1 =Off / 0 =
Switches S1 and S51