Owner's manual

1336 FORCE-5.19 – August, 2000
Startup 3-3
Data Checks- Record motor and drive data and settings in the
following checklists.
Figure 3.1
Nameplate Data
Motor Lead Checks- Disconnect all motor leads from Drive and
Motor. Megger to ground and to each other.
A. Measure U - Gnd, V - Gnd and W - Gnd (This will be very high
resistance), for both master and slave and record this data.
Data Parameter Setting
Motor Nameplate Horsepower #228 Hp
Motor Base Speed #229 rpm:
Motor Rated Current #230 amps:
Motor Rated Voltage #231 Volts:
Motor Nameplate Frequency #232 Hz:
Number of Motor Poles
(Poles = (120xrated freq.) / Sync. Speed)
#233 #:
Encoder PPR #235 PPR:
Rated Inverter Output Amps #220
Rated Inverter Input Voltage #221
Main Control Board Rev Level:
PLC Comm Board (Optional) Rev Level: Switch Settings:
J5:
J10:
J13:
Standard Adapter Board (Optional) Rev Level: Jumper Settings:
U2:
U3:
U4:
U5:
Encoder Name Plate Data
Catalog No.:
Serial No.:
Series:
Motor Name Plate Data
Serial No.:
Series:
Catalog No.:
Drive Name Plate Data
Serial No.:
Catalog No.:
Series: