Manual

1336 FORCE™ To PowerFlex® 700S Phase II AC Drive Conversion Guide

Feedback Encoder Inputs: Incremental, dual channel, isolated with differential

transmitter, Quadrature: 90° ±27° @ 25°C, Duty

Cycle: 50% + 10%.

Two dual channel plus marker, isolated with differential transmitter output (line drive) incremental, dual channel quadrature type.

Encoder PPR Rating:

— Encoder PPR ratings are limited to the values specified in the table below:

Encoder Voltage Supply:

12V DC, 500 mA

5V or 12V, 10mA Min. Inputs

5V DC or 12 V DC 320 mA/channel

5V DC minimum high state voltage of 3.0V DC, maximum low state voltage at 0.4V DC

12 V DC minimum high state voltage of 7.0V DC, maximum low state voltage of 0.4V DC

Maximum Input Frequency:

102.5 kHz 400 kHz

Stegmann Option:

—

Encoder Volt. Supply: 11.5V DC @ 130 mA

Hi-Resolution Fdbk.: Sine/Cosine 1V P-P Offset 2.5

Max. Cable Length: 182 m (600 ft.)

RS-485 Interface: Hi-Resolution Feedback Option card obtains the following information via the Hiperface RS-485 interface shortly after power-up:

Address, Command Number, Mode, Number of turns, Number of Sine/Cos cycles, Checksum

Customer-I/O Plug (P1)

- Hi Res:

Allen-Bradley PN: S94262912

Weidmuller PN: BL3.50/90/12BK

Resolver Option:

—

Excitation Frequency: 2400 Hz

Excitation Voltage: 4.25-26 Vrms

Operating Freq. Range: 1 - 10 kHz

Resolver Fdbk Voltage: 2V ± 300 mV

Max. Cable Length: 304.8 meters (1000 ft.)