Owner's manual

5–13Programming
[Overload Amps]
This value should be set to the motor nameplate Full
Load Amps (FLA) for 1.15 SF motors. For 1.0 SF
motors the value should be set to 0.9 x nameplate
FLA.
Parameter Number 38
Parameter Type Read and Write
Display Units / Drive Units 0.1 Amps / 4096 = Rated Amps
Factory Default 115% of Drive Rating
Minimum Value 20% of Drive Rated Amps
Maximum Value 115% of Drive Rated Amps
[VT Scaling]
This parameter scales the drive for VT ampere
ratings.
This parameter cannot be changed while the drive is
running.
Parameter Number 203
Parameter Type Read and Write
Factory Default “Disabled”
Units Display Drive
“Disabled” 0
Disables Variable Torque Scaling
“Enabled” 1 Enables Variable Torque Scaling
[Motor NP RPM]
This value should be set to the motor nameplate
rated RPM.
This parameter cannot be changed while the drive is
running.
Parameter Number 177
Parameter Type Read and Write
Display Units / Drive Units 1 RPM / 1 RPM
Factory Default 1750 RPM
Minimum Value 60 RPM
Maximum Value 24000 RPM
[Motor NP Hertz]
This value should be set to the motor nameplate
rated frequency.
This parameter cannot be changed while the drive is
running.
Parameter Number 178
Parameter Type Read and Write
Display Units / Drive Units 1 Hertz / Hertz x 10 (x 1 frn<4.01)
Factory Default 60 Hz
Minimum Value 1 Hz
Maximum Value 400 Hz
[Motor NP Volts]– Firmware 4.01 & later
This value should be set to the motor nameplate
rated volts.
This parameter cannot be changed while the drive is
running.
Parameter Number 190
Parameter Type Read and Write
Display Units / Drive Units 1 Volt / 4096 = Drive Rated Volts
Factory Default Drive Rated Volts
Minimum Value 0 Volts
Maximum Value 2 x Drive Rated Volts
[Motor NP Amps]– Firmware 4.01 & later
This value should be set to the motor nameplate
rated current.
This parameter cannot be changed while the drive is
running.
Parameter Number 191
Parameter Type Read and Write
Display Units / Drive Units 1 Amp / 4096 = Drive Rated Amps
Factory Default Drive Rated Amps
Minimum Value 0 Amps
Maximum Value 2 x Drive Rated Amps
Setup