Owner's manual

Index
I–4
Rated CT kW, 5–39
Rated kW, 5–38
Rated VT Amps, 5–39
Rated VT kW, 5–39
Reference Mask, 5–40
Reference Owner, 5–42
Reset/Run Time, 5–23
Reset/Run Tries, 5–22
Run Boost, 5–52
Run On Power Up, 5–22
Run/Accel Boost, 5–15
S Curve Enable, 5–23
S Curve Time, 5–23
Save MOP Ref, 5–20
Set 0–10 Vlt Hi, 5–27
Set 0–10 Vlt Lo, 5–27
Set 4–20 mA Hi, 5–27
Set 4–20 mA Lo, 5–27
Set Anlg Out Hi, 5–28
Set Anlg Out Lo, 5–28
Set Defaults, 5–37
Shear Pin Fault, 5–29
Skip Freq, 5–20
Skip Freq Band, 5–20
Slip Comp Gain, 5–22
Slip@F.L.A., 5–22
Speed Adder, 5–46
Speed Control, 5–22, 5–45, 5–47
Speed Error, 5–46
Speed Integral, 5–46
Speed KI, 5–46
Start Boost, 5–52
Start Mask, 5–39
Start Owner, 5–41
Stop Mode Used, 5–36
Stop Owner, 5–41
Stop Select, 5–11, 5–16, 5–18
Torque Current, 5–9
Traverse Period, 5–25
VT Scaling, 5–13
Password Mode, 3–5
Power Loss Ride-Thru, 5–30
Preset Frequency, 5–19
Process Mode, 3–5
Program Mode, 3–5
Programmable Controller Config., A–14
Programming Flow Chart, 5–1
Pulse Input, 2–23
R
Reactors, 2–4
Remote I/O, 5–43
Reset Defaults, 4–3
S
S Curve, 5–23
Search Mode, 3–5
Serial Communications, A–13
Skip Frequency, 5–20
Software Compatibility, 1–1
Specifications
Control, A–2
Electrical, A–2
Environment, A–1
Input/Output Ratings, A–2
Protection, A–1
Flux Vector vs. V/Hz, 4–5, 4–11
Speed Select Inputs, 2–26
Startup Procedure, 4–1
Status Display, 3–5
T
Terminal Blocks
Auxiliary Output, 2–37
Locations, 2–11
TB1, 2–12
TB2, 2–22
TB3, 2–25
TB4/TB6, 2–36
Traverse Function, 5–25
Troubleshooting
Clearing a Fault, 6–1
Fault Code Cross Ref., 6–7
Fault Descriptions, 6–1
Fault Display, 6–1
U
User Supplied Enclosures, A–4
V
Volts/Hz Pattern, 5–51
W
Wiring
Control and Signal, 2–21
Control Interface, 2–23
Encoder, 2–32
Power, 2–11