User Manual - Firmware 1.xxx-6.xxx Instruction Manual

Start-Up 5–13
Set Electronic
Overload
21. Electronic overload protection is factory set to drive maximum.
A. To properly set the electronic overload protection, program [Overload Amps]
(Setup group) to the actual nameplate F.L.A.
B. If the motor speed range is greater than 2:1, program [Overload Mode] to
the proper derate.
For the typical steps involved when programming, refer to step 15
.
22. This completes the basic start-up procedure. Depending on your application,
further parameter programming may be required. Refer to Chapter 6 for
information.
23. If password protection is enabled, log out as described in Chapter 3.
Advanced Start-Up Procedure
Press these keys . . . while following these steps . . . The HIM Display will show . . .