User Manual - Firmware 1.xxx-6.xxx Instruction Manual

Chapter 5
Start-Up
This chapter describes how you start-up the 1336 PLUS II Drive.
Included are typical adjustments and checks to assure proper opera-
tion. The information contained in previous chapters of this manual
must be read and understood before proceeding.
Important: The 1336
PLUS II is designed so that start-up is simple and
efficient. Two start-up methods are provided. A self
prompting “assisted” procedure utilizing the 1336
PLUS II
Startup mode. As an aid, this mode asks questions about
the most used basic parameters. The second method, if
required, provides a more complex start-up utilizing the
“Program” mode and complete parameter access.
Advanced features and adjustments are grouped separately
from basic parameters for ease of use.
Start-Up Requirements The following procedures are written for users who have a Human
Interface Module (HIM) installed and who are not using a 2-wire
drive control scheme. For users without a HIM, respective external
commands and signals must be substituted to simulate their operation.
Important:
Power must be applied to the drive when viewing or changing 1336
PLUS II parameters. Previous programming may affect the drive
status when power is applied.
If the Control Interface option is installed, remote start circuits may
be connected to TB3 on the interface board. Confirm that all cir-
cuits are in a de-energized state before applying power. User sup-
plied voltages may exist at TB3 even when power is not applied to
the drive.
Refer to Chapter 7 for fault code information.
!
ATTENTION: Power must be applied to the drive to per-
form the following start-up procedure. Some of the voltages
present are at incoming line potential. To avoid electric
shock hazard or damage to equipment, only qualified ser-
vice personnel should perform the following procedure.
Thoroughly read and understand the procedure before be-
ginning. If an event does not occur while performing this
procedure, Do Not Proceed. Remove Power by opening
the branch circuit disconnect device and correct the mal-
function before continuing.