User Manual V 1-4.XX User guide

2-22 Mounting and Wiring Your 1336 IMPACT Drive
The typical analog input connections for unidirectional operation are
shown as follows:
The typical analog input connections for bidirectional operation can
be shown as follows:
-10V DC (Power Supply)
COM (Power Supply Common)
+10V DC (Power Supply)
IN + (Analog In)
IN - (Analog In)
ADC
A
Connect to
either A or C
(only one)
B
C
D
E
Note: Connect to only one set of inputs
-- IN4+ and IN4-
-- IN3+ and IN3-
-- IN2+ and IN2-
-- IN1+ and IN1-
Reference Pot
2.5 k
Ω Minimum
To TE
(Signal Ground Terminal Block)
Shield F
A1–A4 B–H
A J4–3TB10–3
B J4–2TB10–2
C J4–1TB10–1
D J7–1TB10–4
E J7–2TB10–5
F J7–3TB10–6
Frames
-10V DC (Power Supply)
COM (Power Supply Common)
+10V DC (Power Supply)
IN + (Analog In)
IN - (Analog In)
ADC
A
Forward
Reverse
B
C
D
E
Note: Connect to only one set of inputs
-- IN4+ and IN4-
-- IN3+ and IN3-
-- IN2+ and IN2-
-- IN1+ and IN1-
Reference Pot
2.5 k
Ω Minimum
To TE
(Signal Ground Terminal Block)
ReverseForward
R
Reverse
Relay
Shield
F
A1–A4 B–H
A J4–3TB10–3
B J4–2TB10–2
C J4–1TB10–1
D J7–1TB10–4
E J7–2TB10–5
F J7–3TB10–6
Frames
If you are wiring a remote pot to your system, you may want to refer
to Chapter 9, Applications, and Appendix B, Control Block
Diagrams, for additional information.