User Manual V 1-4.XX User guide

Troubleshooting 12-23
3. Enter a value of 10504 into Test Select 2 (parameter 95).
4. Look at the value of Test Data 2 (parameter 94). If Test Data 2 is
zero, no parameters in this group are being limited. If Test Data 2
is non-zero, use the following table to determine which parameter
is being limited.
The parameter limit testpoints are cleared when you clear the faults.
Once you know which parameter(s) is being limited, you can
determine why the parameter was limited. In many cases, a link from
the limited parameter to another parameter will explain how the limit
value was reached. For example, a link to an analog input value.
4 (bit 2)
Min Flux Level
(parameter 71)
The minimum/maximum range
8 (bit 3)
Pos Mtr Cur Lim
(parameter 72)
The minimum/maximum range
16 (bit 4)
Neg Mtr Cur Lim
(parameter 73)
The minimum/maximum range
32 (bit 5)
Current Rate Lim
(parameter 77)
Positive numbers
128 (bit 7)
Max Rev Spd Trim
(parameter 61)
Zero or negative numbers
256 (bit 8)
Max Fwd Spd Trim
(parameter 62)
Zero or positive numbers
If Test
Data 2 is:
Then this
parameter:
Has been
limited to:
4 (bit 2)
Ki Speed Loop
(parameter 158)
The minimum/maximum range
8 (bit 3)
Kp Speed Loop
(parameter 159)
The minimum/maximum range
16 (bit 4)
Kf Speed Loop
(parameter 160)
The minimum/maximum range
32 (bit 5)
Fdbk Device Type
(parameter 64)
The minimum/maximum range
64 (bit 6)
Fdbk Filter BW
(parameter 67)
The minimum/maximum range
128 (bit 7)
Inverter Amps
(parameter 11)
The minimum/maximum range
512 (bit 9)
Error Filtr BW
(parameter 162)
The minimum/maximum range
1024
(bit 10)
Nameplate RPM
(parameter 3)
The minimum/maximum range
2048
(bit 11)
Encoder PPR
(parameter 8)
The minimum/maximum range
4096
(bit 12)
Nameplate Amps
(parameter 4)
The minimum/maximum range. Nameplate
Amps must be less than or equal to twice
Inverter Amps (parameter 11).
-32768
(bit 15)
Droop Percent
(parameter 46)
The minimum/maximum range
If Test
Data 2 is:
Then, this
parameter:
Has been
limited to: