Owner's manual

1336-5.49 – August, 1999
I-23
1. Access the SCR Module. Refer to “SCR Module Access” on
page I-11.
2. Install the Preform between the SCR Module and the Snubber
Board as shown in Figure I-10, View A.
3. Attach the Snubber Board connecting wire to the SCR Module as
shown in Figure I-10, View B. Finger-tighten the nuts, alternating
between the two, 1/4 turn at a time. Refer to “Torque Sequence”
on page I-4. Refer to “Torque Specifications” on page I-11 for
final tightening.
Assemble the drive in reverse order of removal.
!
ATTENTION: Replace all guards before applying
power to the drive. Failure to replace guards may result
in death or serious injury.