User Manual

2–31Installation/Wiring
Important: If the Control Interface Board is being installed, Main
Control Board jumpers at pins 3 & 4 and 17 & 18 of J4
(J7 on B Frame & up drives) must be removed and the
proper [Input Mode] selected. If this board is removed,
these jumpers must be reinstalled and the [Input Mode]
parameter must be programmed to “1.”
Figure 2.7
Jumper Locations
LANGUAGE MODULE
ALLEN-BRADLEY
LANGUAGE MODULE
ALLEN-BRADLEY
J
O
G
E
S
C
S
E
L
J
O
G
E
S
C
S
E
L
J7
J4
A Frame Drives
1
B Frame Drives
1
1
Refer to page 1–1 for frame reference classifications.
Interface Board
Installation and Removal