User Manual

5–39Programming
This group of parameters contains binary information to display which group of adapters
are issuing control commands.
Owners
Each Owner Parameter contains a bit for each
adapter. The drive will set an adapter’s bit to “1”
when that adapter is issuing a logic command and
to “Zero” when no command is being issued.
With a Series A (version 3.0) or Series B HIM, a
Status description (bit ENUM) is displayed on line
1.
TB3
Adapter 1
Adapter 2
Adapter 3
Adapter 4
Adapter 5
Adapter 6
Not Used
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Owners Display
[Stop Owner]
This parameter displays which adapters are
presently issuing a valid stop command.
Parameter Number 102
Parameter Type Read Only
Units Display Drive
“0” 0
Stop Input Not Present
“1” 1 Stop Input Present
[Direction Owner]
This parameter displays which adapter currently has
exclusive control of direction changes.
Parameter Number 103
Parameter Type Read Only
Units Display Drive
“0” 0
Non-Owner
“1” 1 Current Owner
[Start Owner]
This parameter displays which adapters are
presently issuing a valid start command.
Parameter Number 104
Parameter Type Read Only
Units Display Drive
“0” 0
Start Input Not Present
“1” 1 Start Input Present
[Jog Owner]
This parameter displays which adapters are
presently issuing a valid jog command.
Parameter Number 105
Parameter Type Read Only
Units Display Drive
“0” 0
Jog Input Not Present
“1” 1 Jog Input Present
[Reference Owner]
This parameter displays which adapter currently has
the exclusive control of the selection of the
command frequency source.
Parameter Number 106
Parameter Type Read Only
Units Display Drive
“0” 0
Non-Owner
“1” 1 Current Owner
[Accel Owner]
This parameter displays which adapter has
exclusive control of selecting [Accel Time 1] or
[Accel Time 2].
Parameter Number 107
Parameter Type Read Only
Units Display Drive
“0” 0
Non-Owner
“1” 1 Current Owner