User Manual

5–35Programming
[Heatsink Temp]
This parameter displays the heatsink temperature.
Parameter Number 70
Parameter Type Read Only
Display Units / Drive Units 1° C / Deg. C
Factory Default None
Minimum Value 0
Maximum Value 255° C
[Set Defaults]
Setting this parameter to “Defaults Init” resets all
parameters to their factory values.
This parameter cannot be changed while the drive is
running.
Parameter Number 64
Parameter Type Read and Write
Factory Default “Ready”
Units Display Drive
“Ready” 0
Display after function complete.
“Store to EE” 1 Not implemented.
“Rcll frm EE” 2 Not implemented.
“Default Init” 3 Resets all parameters to factory
settings.
[Application Sts]
The value of this parameter provides a checksum
value that indicates a change in drive programming
has occurred.
With a Series A (version 3.0) or Series B HIM, a
Status description (bit ENUM) is displayed on line 1.
Parameter Number 200
Parameter Type Read Only
Factory Default 00000000
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Sync Input – 0 = Disabled, 1 = Enabled
P Jump – 0 = Disabled, 1 = Enabled
Unused
[DC Bus Memory]
This parameter displays the nominal DC bus voltage
level. This value is used to determine line loss,
overvoltage, decel frequency and other points.
Parameter Number 212
Parameter Type Read Only
Display Units / Drive Units 1 Volt / Volts
Display Volts
Diagnostics