User Manual
Operation
Chapter 7
7-5
Fault Display Fault codes appear if the drive detects a fault condition.
Freq
P
R
Parameter Programming Display Parameter values appear when viewing or programming drive parameters.
Freq
P
R
Operating Display The Pr display is a two character display that shows the frequency source
when the drive is in Standby, Jog or Running.
Freq
P
R
– 0 Control Panel speed pot – 5 TB2 speed pot input
– 1 0 to +10V input – 6 Jog selected
– 2 4-20mA input – 7 Preset Speed 1
– 3 Pulse train input – 8 Preset Speed 2
– 4 Serial input – 9 Preset Speed 3 or if Parameter 72 is
set to 1, Preset Speeds 4-7
Important: No dash indicates a parameter number rather than a frequency
source.
Parameter Viewing Display The parameter number appears when viewing parameters.
Freq
P
R