User Manual

Summary of Changes
Summary of Changes
Summary of Manual Changes This release of the 1333-5.2 User Manual contains some new and corrected
information. The new and corrected information is summarized in the table
below. For further information, refer to the page numbers provided.
Description of New or Corrected Information Page Type
Drive Input Terminals 48 Correction
Recommended Wire Size and Torque 415 Correction
SW2 Factory Setting -- Figure 45 420 New
Terms 6 & 3 Analog Meter Output
Meter Load Impedance 422 Correction
Terms 13 & 14 -- S1/4SP
Terms 13 & 14 -- S2/4SP
SW2 Factory Setting 424 New
Parameter 02 -- Deceleration Time 1
From 00.011000 seconds . . . sets the decel time . . . 59 Correction
From 10001600 seconds . . . sets the decel time . . . 59 Correction
Local/Remote Control Enable
If set to 0 . . .
w Local Jog can be selected by . . . the Shift button. 514 Correction
If set to 2. . .
w Local Jog can be selected by . . . the Shift button. 515 Correction
1. SW2 Factory Setting 524 New
As shown in Figure 45 in Chapter 4
If Parameter 19 = 0
When Control Board Switch SW2 is Set to . . . 525 Correction
If Parameter 19 = 1
When Control Board Switch SW2 is Set to . . . 525 Correction
If Parameter 19 = 2
When Control Board Switch SW2 is Set to . . . 525 Correction
As shown in Figure 45 in Chapter 4
If Parameter 19 = 0 and Parameter 20 = 0
When Control Board Switch SW2 is Set to . . . 526 Correction
If Parameter 19 = 1 and Parameter 20 = 0
When Control Board Switch SW2 is Set to . . . 526 Correction
If Parameter 19 = 2 and Parameter 20 = 0
When Control Board Switch SW2 is Set to . . . 526 Correction
As shown in Figure 45 in Chapter 4
If Parameter 19 = 0 and Parameter 20 = 1
When Control Board Switch SW2 is Set to . . . 527 Correction
If Parameter 19 = 1 and Parameter 20 = 1
When Control Board Switch SW2 is Set to . . . 527 Correction
If Parameter 19 = 2 and Parameter 20 = 1
When Control Board Switch SW2 is Set to . . . 527 Correction
Preset Frequency Settings
Auxiliary Accel and Decel Settings 534 Correction