Owner's manual

1329I-5.5 Integrated Drive/Motor — January, 2000
Appendix D
Installation Record
Record the switch settings for your setup in the diagrams below.
Catalog Number:
0 = 1 Second Accel/5 Sec Decel
1 = 5 Seconds (Default)
2 = 10 Seconds
3 = 15 Seconds
4 = 20 Seconds
5 = 30 Seconds
6 = 60 Seconds
7 = 90 Seconds
0 = 1500 RPM (50 Hz)
1 = 1800 RPM (60 Hz) Default
2 = 2100 RPM (70 Hz)
3 = 2400 RPM (80 Hz)
4 = 2700 RPM (90 Hz)
5 = 3000 RPM (100 Hz)
6 = 3300 RPM (110 Hz)
7 = 3600 RPM (120 Hz)
OFF ON
Enabled
Terminal Block
Faulted
Enabled
Constant
Ramp-to-Rest
Disabled
From Terminal Block
From Terminal Block
From EEPROM Memory
Run On Power Up
Speed Reference ➊
Relay Control Output
Auto Restart
Torque Curve
Stop
Reverse
Minimum Speed
Start Mode ➊
Parameter Mode ➋
Disabled
Operator Controls
Running
Disabled
Variable
Coast-to-Rest
Enabled
0 Hz
Operator Controls
Setup Switches
Max Speed Switch
(SW2)
Accel/Decel Switch
(SW1)
Setup DIP Switch
(SW3)
➊ Switches 2 and 9 apply to local operator control units only.
➋ Switch 10 applies to the DeviceNet Communication option only.