User Manual

Programming
5-40
Faults Group (continued)
[
Cur Lim Tri
p
En
]
Parameter # 82 Factory Default ‘‘Default Run”
[Cur
Lim
Trip
En]
Parameter Type Read & Write
This setting determines whether or not exceeding the
setting in [Current Limit] will cause a Diagnostic Current
Units Text Setting ‘‘Trip @ I Lim”
A Diagnostic Current Limit Fault is generated
sett
i
ng
i
n
[C
urrent
Li
m
i
t
]
w
ill
cause a
Di
agnost
i
c
C
urrent
Limit Fault (Fault F36).
‘‘Default Run”
No fault generated
[
Line Loss Fault
]
Parameter # 40 Factory Default ‘‘F03 Enable”
[Line
Loss
Fault]
Parameter Type Read & Write
This setting determines whether a 15% drop in DC Bus
voltage will have no effect on operation or cause a ‘‘Power
Loss Fault”
(
fault F03
)
.
Units Text Setting ‘‘UVolt Run”
‘‘Power Loss Fault” Disabled
Loss
Fault
(fault
F03)
.
Important
:The “Line Loss” alarm bit will be set when this
condition exists regardless of the parameter setting.
‘‘FO3 Enable”
Drive Trips at 85% of nominal bus voltage.