Owner's manual

Chapter 5 –Programming
5-46
Diagnostics Group (cont.)
[Power Mode]
Parameter # 44
Parameter Type Read Only
This parameter is used for internal diagnostic purposes.
[D
r
iv
e
Type
]
Parameter # 61
[D
r
iv
e
Type
]
Parameter Type Read Only
This parameter displays a decimal number that identifies
the drive.
Units None
[D
r
iv
e
Fi
r
mw
are
]
Parameter # 71 Factory Default None
[D
r
iv
e
Fi
r
mw
are
]
Parameter Type Read Only Display 0.00
This parameter displays the version number of the drive
firmware.
[
O
ut
p
ut
P
u
l
s
e
s]
Parameter # 67 Factory Default None
[
O
ut
p
ut
P
u
l
s
e
s]
Parameter Type Read Only Minimum 0
This parameter displays the number of output cycles for
the PWM waveform. The count rolls over at 65535.
Units Cycles Maximum 65535
[Drive Temp]
Parameter # 70 Factory Default None
[D
r
iv
e
Te
m
p
]
Parameter Type Read Only Minimum 0_C
This parameter displays the internal drive temperature. Units 1_C Maximum 100_C
[
Se
t D
e
f
a
u
l
ts]
Parameter # 64 Factory Default ‘‘Ready”
[
Se
t D
e
f
a
u
l
ts]
Parameter Type Read & Write
Setting parameter to ‘‘Default Init” resets all parameters to
er r v ues See s p e M M de
Units None Settings ‘‘Ready”
Display After Function Complete
Se
tting
p
a
r
am
e
t
er
to
‘‘
D
e
fa
u
lt Init”
rese
t
s
all
p
a
r
am
e
t
ers
to
their factory values. See also page 3-12 EEPROM Mode.
Note: This parameter can not be programmed while
the drive is running.
‘‘Store to EE”
‘‘Recll frm EE”
‘‘Default Init”
Saves parameter Ram to EEPROM
Restores parameter Ram from EEPROM
Resets All Parameters to Their Factory Settings